Installation and user guide- 13
6 Recommendations for remote siren installation
To install and use your remote siren, you will need the following elements and tools:
1 remote siren (the red and white case)
1 power supply 110V/12V, 450mA
1 fixation kit (bag including 2 screws and tapping inserts)
1 cross-shaping screwdriver.
1 Ø 0.25 in (6mm) concrete drill and the associate driller.
IMAGE 1
The remote siren shall be installed 70 feet max. away from TRITON™. This is not an outdoor siren
and so should be installed in premises away from bad weather.
-
Operating principle
o
The remote siren is remotely driven by the TRITON™ via radio frequencies.
o
If a fall is detected by TRITON™ in the pool, the TRITON™ siren and the remote siren will trigger
simultaneously.
o
It is impossible to stop the sirens from the remote device. It is imperative to go to the pool, check
what triggered the sirens, act if necessary and stop the sirens by typing the password. (initially:
1234)
o
Like the TRITON™ main device, if you don’t stop the siren by typing the password after a trigger,
the remote siren will stop automatically after 3 minutes.
-
Synchronization
To enable a link between the TRITON™ and the remote siren, you should synchronize the two
devices.
a) Choose a location for your remote device
o
70 feet away (max) from the TRITON™
o
Near an electrical plug.
b) Plug the power supply to the remote siren.
IMAGE 2
c) Plug the power supply on the electrical plug, a PIP sound, and your remote device is installed.
IMAGE 3
d) Launch the synchronization mode of the remote system by pressing the black button on the side
of the red and white case.
e) Switch on MANUAL mode by typing the manual code 112344 on your TRITON™. (The LED
:
blinks in yellow).
IMAGE 4
f) Launch the synchronization of the TRITON™ by pressing the synchronization code 3333 ((the
LED
:
blinks in green). The remote siren should beep.
g) Stop the synchronization mode of the remote system by pressing the black button on the side of
the red and white case.
h) Switch your TRITON™ to DETECTION mode by typing your password (initially 1234). Both
systems should beep.
i)
Perform a falling test in your pool to validate your radio link. Stop both sirens by typing the
password (initially 1234).
o
You can synchronize one or more TRITON™ with one or more sirens. In that case you should
repeat on each TRITON™ the e) and f) steps followed by pressing the black button on each
remote siren(s).
o
You can reset the remote siren by pressing lengthily on the black button (3 seconds). You will
have to restart the whole synchronization process.
-
Installation
