11
For the coaming you need:
4x coaming rod (2 of them with D-ring)
2x short coaming rod
(come connected)
Connect one of the bent rods
with
D-ring
with one of the short rods.
Insert these with the short part ahead into
the coaming channel. And that into the
part with the largest gap in the rear third
(see the left picture)
.
Then slide this first half of the coaming
through the channel to the front.
It is much easier to push the coaming rod
“from the inside of the boat”, rather than
“from above”. This creates a “straight line”
and prevents jamming inside the channel.
Thus, the rods are much easier to push
into the channel!
Then connect the coaming rod with the
pickup element in the bow by sliding it
onto it. Just pull the flexible part a bit
toward you, so that there is also a straight
line. Thus the connection of coaming rod
is much easier.
Proceed likewise on the other side.
Then push the remaining two coaming
rods without D-ring into the channel
towards the stern and connect them to the
flexible pickup elements in the stern.
Attention: Do not connect the coaming
in the middle, yet!
First the stringer
elements have to be connected in the next
step:
