Bezique
fiTTiNG THE riSEr rail
Decide the position for the rail on the wall
within the shower area. Proceed as follows:
Offer one of the brackets to the wall for the
lower position only. note there are three holes
in the brackets but two screws will usually be
enough. Mark the centre hole and one of the
other two.
Drill and plug the wall.
(The wall plugs provided
are suitable for most brick walls — use an
appropriate masonry drill, but if the wall is
plasterboard or a soft building block, you must use
suitable wall plugs and an appropriate drill bit)
.
Replace the bracket to the wall and secure to the
wall with the screws supplied
(fig.)
. Locate
the rail onto this lower bracket, making sure the
rail engages fully on the bracket. Check that the
indent in the riser rail engages into the cut-out
on the bracket end
(fig.)
.
Locate the second bracket on top of the rail.
Check the rail is vertical then mark the centre
hole and of the other two holes. Remove the
bracket and rail. Drill and plug the wall.
Fit the lever/saddle assembly, spacer and slider/
holder assembly together
(fig.)
.
make sure
the lever is pointing upwards and the holes
align.
Note:
The showerhead holder will only fit onto
the riser rail one way.
Slide onto the rail
(fig.)
and tighten to the
rail by turning the lever. When tight, the lever
should be facing forwards and not pointing to
the wall. If not, slacken off and remove from the
rail. Rotate the saddle and lever 180° within the
slider/holder assembly then replace onto the rail
and tighten.
WARNING!
check there are no hidden cables or
pipes before drilling holes for wall
plugs. use great care when using
power tools near water. the use of
a residual current device (Rcd) is
recommended.
Lever
Spacer
Slider/holder
assembly
Fig.
Fig.
Fig.
Fig.
Fig.
