
Bar mixer shower
10
FITTING THE RISER/FIXED HEAD RAIL
• Mark the centre hole for the wall bracket
(see
fig.10).
• Drill and plug the wall. The wall plugs are
suitable for most brick walls – use an appropriate
masonry drill, but if the wall is plasterboard or a
soft building block, use suitable wall plugs and
an appropriate drill bit.
• Secure the bracket to the wall.
Note
The elongated hole in the wall bracket allows
for a small amount of adjustment.
RISER KIT ASSEMBLY
• Seat the upper part of the rail into the rail
support, making sure the bracket engages
the hexagonal fitting and the ‘O’ ring is in
place
(fig.11)
.
• Using a suitable screwdriver, tighten the
retaining screw to secure the rail into the
support. Screw the bottom part of the rail to
the upper section and tighten.
Note
The upper and lower riser pipework MUST not
be cut. The product may not perform within
stated specifications if altered. Alterations may
invalidate the warranty.
FITTING THE SHOWERHEAD HOLDER
While depressing the button on the showerhead
holder
(fig.12)
, slide the holder onto the rail
below the bracket.
Fig.10
Fig.11
Slider/holder
assembly
Press and hold
button to unlock
mechanism
Lower shower arm
Fig.12
Upper rail
bottom rail
‘O’ ring
Rail support
Retaining
screw