Triton Systems ©
21
remove the nmd 100 dispenser
WARNING
Triton recommends using two people to remove the dispensing mechanism to prevent injury to service person-
nel and/or to prevent damage to dispensing mechanism or cabinet.
The dispensing mechanism for the ARGO FT will be installed in the cabinet/vault during shipping. Protective
foam blocks are placed behind and along each side of the dispenser to prevent damage during transit. The foam
blocks must be removed before the NMD 100 dispenser is uninstalled or put into service.
For customers outside the US, see Appendix B for alternate dispenser options.
1. Unlock and open the top cabinet door. Verify that the power switch on the power supply is in the off
(O)
position.
2. Open the security vault and remove all protective foam or cardboard blocks from around the dispensing
mechanism.
3. On the dispenser, remove the
5/32
” allen screws on the top, front of each slide rail. Discard after removal.
4. Disengage the locking pin on the left slide rail by pulling up on the locking pin, then sliding the dispenser
out.
locking pin
allen screw
5. Pull dispensing mechanism out of the cabinet until it reaches a fully extended position.