XM1093-V1.2.0-NR
31
performing reset more than 2 times, only the channels which have errors can not work properly,
others can work as usual. Please contact with dealer or manufacturer for service, self repair is not
allowed.
PAN Er
(PAN-yoke movement error) This message will appear after the reset of the fixture if the yoke’s
magnetic-indexing circuit malfunction (sensor failed or magnet missing) or the stepping-motor is
defective (or its driving IC on the main PCB). The PAN- movement is not located in the default
position after the reset.
TILT Er
(TILT-head movement error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the stepping-motor
is defective (or its driving IC on the main PCB). The TILT- movement is not located in the
default position after the reset.
Color Wheel Er
(Color wheel- error) This message will appear after the reset of the fixture if the
magnetic-indexing circuit malfunction (sensor failed or magnet missing) or the stepping-motor is
defective (or its driving IC on the main PCB). The color wheel is not located in the default
position after the reset.
Gobo Wheel 1 Er
(Gobo Wheel 1-head movement error) This message will appear after the reset of the fixture if
the head’s magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the
stepping-motor is defective (or its driving IC on the main PCB). The Gobo Wheel 1- movement
is not located in the default position after the reset.
Prism_R Er
(Prism_R -head movement error) This message will appear after the reset of the fixture if the
head’s magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the
stepping-motor is defective (or its driving IC on the main PCB). The Prism_R - movement is not
located in the default position after the reset.
Focus Er
(Focus -head movement error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the stepping-motor
is defective (or its driving IC on the main PCB). The Focus - movement is not located in the
default position after the reset.
Frost Er
(Frost -head movement error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the stepping-motor
is defective (or its driving IC on the main PCB). The Frost - movement is not located in the
default position after the reset.
11. CLEANING AND MAINTENANCE
The following points have to be considered during the inspection:
1) All screws for installing the devices or parts of the device have to be tightly connected and
must not be corroded.
2) There must not be any deformations on the housing, color lenses, fixations and installation
