IP2032 Quick Reference Operating Guide
Page 18 of 34
Basic Call Features
Operation
Description
Making a Call
1.
Pick-up the handset. You will hear dial tone.
2.
Use the keypad to dial a phone number. Press
the ENTER key or “Dial” softkey to dial out
immediately, or wait for the Dial Timeout setting
to auto-end the dialing. The Phone will then send
out the dialed number to eNet660S. The
eNet660S will route the call to the appropriate
destination.
Note: You can use the “Backsp” softkey to
delete any digits entered.
3.
Start talking to called party.
4.
Place the handset On-hook when you finished
the conversation.
There are three mode to establish a call for this IP phone, handset
mode, hands-free mode and headset mode. In this manual, only
handset mode is used for example. In the following features, you can
replace
to hands-free mode by pressing
key or headset
mode by pressing
and
key. When the conversation is
over, press
key again to release call. For headset mode,
please prepare a headset first.
Making a Call via
Specific Trunk
1.
Pick-up the handset. You will hear dial tone
played.
2.
Press a line key 1 or 2. The LED of line key will
light and the specific trunk line will be engaged.
Use the keypad to dial the target phone number.
Press # key to dial out immediately, or wait for
the Dial Timeout setting to auto-end the dialing.
3.
User can also dial the PSTN or IP trunk access
number which the eNet660S registered. For
detail about IP and PSTN trunk, refer to the
eNet660S manual.
Note: You can use the “Backsp” softkey to
delete the last digit.
4.
Start talking to the called party.
