6
Installation
3-4
Connect Accessory to Network:
Connect a standard Ethernet patch cable to
the RJ45 Ethernet port on the Accessory.
Note: This port does not support PoE
(Power over Ethernet) applications.
3-5
Connect Accessory to Power:
(Refer to Figure 1, Figure 2a or Figure 2b.)
There are two ways to connect the Accessory to power:
• Connect the AC Adapter
A
to the Accessory via the port labeled “DC Power”
B
and plug the other end into an AC power source supported by a UPS
(Figure 1) or Inverter/Charger (Figure 2a).
• Connect one end of the 12V DC Cable
A
to the Accessory via the port
labeled “DC Power”
B
and connect the other end
I
directly to the Inverter/
Charger
J
. This feature is available on select models only.
Note: The Accessory must be plugged into a power source protected by a UPS or
Inverter/Charger in order to maintain communications during a power outage.
3-6
Connect Accessory to Device:
(Refer to Figure 1, Figure 2a or Figure 2b.)
Using the standard serial cable provided, connect one end to the Accessory port
labeled “UPS/APS”
C
and the other end to the DB9 serial port on your UPS or
Inverter/Charger
D
.
Figure 2B
INVERTER/CHARGER
A
I
J
E
G
H
F
B
C
D
201110124-93-3108.indb 6
11/3/2011 11:59:52 AM
