7
Installation
3-7
Configure Accessory in Terminal Mode:
Note: The Accessory must be
reinitialized by pressing the reset button (located between the "Link" and "Status"
descriptions under the RJ45 port on the Accessory), for 3 seconds.
After the
brief message shown below, an initialization page should appear in the terminal
emulation program. Press any key on the keyboard within 10 seconds to change
the Accessory's settings (If the 10-second period has elapsed, you can reinitialize
the Accessory).
Note: The following message will appear in the terminal startup menu:
IAM:Got AUTO-CONFIGURED IPv6 address FE80::4200:FF:FE01:8 on interface eth0:3
IPv6 is not currently supported. Tripp Lite is working on IPv6 for a future release.
Follow the sequence of responses below in order to assign an IP address to the
Accessory. The default terminal mode password is TrippLite. Sample IP settings
are shown - supply your own IP information when you configure your Accessory.
This card's hostname [ ]?
This card's domain [ ]?
Obtain IP settings automatically using
DHCP for Ethernet interface? [Y]
IP address? [10.2.0.98]
Subnet mask? [255.0.0.0]
Gateway address? [10.0.0.1]
DNS server 1? [10.0.0.5]
DNS server 2? [10.2.0.10]
This cards host name? [cornflakes]
This cards domain? [tlsoftwaredev.local]
SNMP Settings
Enable SNMP Community 0 [Y]? y
Choose a community privilege level:
0 - noAccess
1 - v1UserReadOnly
2 - v1UserReadWrite
3 - v2cUserReadOnly
4 - v2cUserReadWrite
Privilege Level [4]:
Community Name [tripplite]:
Allowable Address Range : [0.0.0.0]?
Allowable Address Mask : [0.0.0.0]?
Enable SNMP Community 1 [N]? n
Enable SNMP Community 2 [N]? n
Enable SNMP Community 3 [N]? n
Note: Default SNMP access is:
Community 0 enable with v2 read only
community public
Community 1 enable with v2 read/write
community tripplite
201110124-93-3108.indb 7
11/3/2011 11:59:52 AM
