5
1b. Mount on Solid Brick or Concrete Block
Insert the two plastic covers
on wall plate for decorative
appearance.
WARNING
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or
“cinder block”), verify that the actual concrete thickness is at least 35 mm (1 3/8”)
in order to hold the concrete anchors. DO NOT DRILL INTO MORTAR JOINTS! Be sure
to mount the wall mount with the included concrete anchors and anchor bolts onto
solid sections of the blocks. The solid sections can generally be found 25 mm (1”)
toward the middle of the block from either end. An electric drill on a slow setting is
suggested to drill the hole rather than a hammer drill so as to avoid breaking out the
back of the hole when entering a hollow section.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
Screw the wall
mount onto
the wall
Drill pilot holes
2
Find and mark the exact
location of mounting holes
1
Concrete Anchor
Anchor Bolt
50 mm
(2”)
8 mm
0.31”)
15-09-382-933501-EN.indd 5
10/7/2015 10:12:53 AM
