9
Remote Repeater Installation
13
Using Cat5e/6 cable, connect the RJ45 output port on the last
repeater to the RJ45 input port on a B126-1A0 or B126-1A0-WP-1
receiver.
14
Connect a monitor to the HDMI output port on the receiver using a
Tripp Lite P568-Series High-Speed HDMI cable.
15
Connect the external power supply to the active remote receiver
unit, and plug it into a Tripp Lite Surge Protector, PDU, or UPS. When
receiving power, the Green RJ45 LED on the B126-1A0 and the
Green
Power
LED on the B126-1A0-WP-1 will illuminate.
Repeat steps 7 through 15 for the remaining
Output
ports on the switch.
16
Turn on power to the connected devices. The Orange RJ45 LEDs
on the B126-2X2, B126-4X4, B126-110, and B126-1A0, and the
Orange
Activity
LED on the B126-1A0-WP-1 will illuminate. The video
image should now be displayed on the connected monitors.
17
If necessary, use the
Equalization
control on the repeater and receiver
units to adjust the video image.
Note:
An improper
Equalization
setting can cause the monitor not to display an image at all.
Try each setting until an acceptable image is displayed.
18
Press the switch next to each set of
Output
LEDs to switch the
source being displayed on the corresponding
Output
monitor. You
can also use the included remote control to switch between sources.
As with the switch next to the
Output
LEDs, press the button on the
remote control of the desired
Output
port to switch the source being
displayed.
Note:
The same 4 button remote control comes with both the B126-2X2 and B126-4X4.
Buttons 3 and 4 will not be used for the B126-2X2.
See the
RS-232 Serial Control
section in this manual for details on
controlling the switch using Terminal Emulation Software.
14-11-047-9333F8.indd 9
11/10/2014 3:14:36 PM
