7
Remote Repeater Installation
Note:
1. Test to make sure that the entire installation works properly before pulling cables through
ceilings/walls.
2. 24AWG, Solid Wire Cat5e/6 cable (such as Tripp Lite’s N202-Series) is required to achieve
maximum distance and resolution.
3. The diagram below shows a B126-2X2 installation. Installation will be the same for the
B126-4X4, except for the number of ports.
4. The back panel of the B126-4X4 contains an IR port which has been capped off. This port is
intended for future use, and does not currently function.
B126-2x2
B126-110
B126-110
B126-110
Up to 175 ft. at 1080i @ 60Hz
Up to 125 ft. at 1080p @ 60Hz
B126-1A0-WP-1
B126-110
B126-110
B126-110
Up to 175 ft. at 1080i @ 60Hz
Up to 125 ft. at 1080p @ 60Hz
Blu-Ray™
Cable Box
or DVR
B126-1A0
0
1
2 3
4
5
6
7
0
1
2 3
4
5
6
7
0
1
2 3
4
5
6
7
0
1
2 3
4
5
6
7
0
1
2 3
4
5
6
7
0
1
2 3
4
5
6
7
Computer
1
Make sure all devices being connected are turned off.
2
Optional:
Using the 3.5 mm to DB9 adapter cable, insert the 3.5
mm connector into the port labeled “RS-232” on the switch. Then
connect the DB9 connector to a serial port on the computer you will
be controlling the switch with.
3
Optional (B126-4X4 only):
Connect the IR extension cable to the
3.5 mm jack on the rear of the unit. Position the cable’s infrared
sensor in an area that allows a direct line of sight between it and the
remote.
4
Connect the first HDMI source to the port on the switch marked
Source A
.
14-11-047-9333F8.indd 7
11/10/2014 3:14:36 PM
