6
Standard 1 x 2 Extender Kit Installation
1
Make sure all devices being connected are powered OFF.
2
Connect the HDMI source to the
INPUT
port on the transmitter unit
using a Tripp Lite P568-Series High-Speed HDMI Cable.
3
Optional:
Connect a monitor to the
LOCAL
port on the transmitter
unit using a Tripp Lite P568-Series High-Speed HDMI Cable.
4
Connect the external power supply to the transmitter unit and plug the
transmitter unit into a Tripp Lite Surge Suppressor, Power Distribution
Unit (PDU), or Uninterruptible Power Supply (UPS). The green RJ45 LED
illuminates to indicate that the unit is receiving power from the external
power supply.
5
Using Cat5e/6 cable, connect the RJ45 port on the transmitter unit
marked
OUTPUT
to the RJ45 port on the receiver unit marked
INPUT
.
6
Connect the external power supply to the receiver unit and plug the
receiver unit into a Tripp Lite Surge Suppressor, Power Distribution Unit
(PDU), or Uninterruptible Power Supply (UPS). The green RJ45 LED
illuminates to indicate that the unit is receiving power from the external
power supply.
7
Connect a monitor to the
OUTPUT 1
port on the receiver unit using a
Tripp Lite P568-Series High-Speed HDMI cable.
8
Repeat step 7 for the
OUTPUT 2
port on the receiver unit.
9
Turn on the power to the connected devices. The orange RJ45 LED’s
on the transmitter and receiver units illuminate to indicate that a
signal is being received from the HDMI source. The video image will
now be displayed on the connected monitors.
10
If necessary, use the
Equalization
control on the receiver unit to adjust
the video image.
Note:
An improper Equalization setting can cause
the monitor not to display an image at all. Try each setting until an
acceptable image is displayed.
13-08-043 93-32D0.indd 6
8/28/2013 2:17:38 PM
