CO Alarm
The meter features an audible alarm (80db beep) that warns when
CO concentration exceeds the set limit. The beeper stops when the
readings fall below the limit. The meter beeps again if the value
exceeds the limit. See the section ‘Setup Mode’ for more
information.
Auto Power OFF
The meter turns off automatically after 20 minutes of inactivity. To
override the function, long press both the
/SET and H/
buttons
while powering ON the meter until “n” appears in the display.
NOTE: Auto power off is not operational while in calibration mode.
Setup Mode
While the meter is OFF, long press the
/SET button to enter the setup
mode.
To exit the setup mode, short press the
/ESC button at any time
during setup.
P10 Clearing the Manual Recording Memory
Clearing the memory will erase ALL the manually stored records.
1.
Upon entering setup mode, P10 and “CLr” display on the LCD.
2.
Short press the MXMN/AV/
button to advance to P11 and
make a selection.
3.
Short press the H/
or MEM/
button to select YES or
NO. ‘YES’ will erase all the manually stored records.
4.
Short press the MXMN/AV/
button to save the selection and
return to P10.
5.
Short press the
/ESC button to exit without saving.
6.
Short press the H/
button to advance to the next step.
