Herrtronic
®
Model 6000
I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l
10
www.trioniaq.com
CYLINDER FILL/DRAIN PORT
POWER WIRE CONNECTIONS
ELECTRODE CONNECTION
CYLINDER FULL ELECTRODE CONNECTION
PROTECTIVE BOOT
(SHOWN TRANSPARENT FOR CLARITY)
(SHOWN TRANSPARENT FOR CLARITY)
PROTECTIVE BOOT
GROMMET
1/4" LOCK WASHER
RED POWER WIRE
1/4"-20 NUT
1/4"-20 NUT
BLACK POWER WIRE
1/4" LOCK WASHER
EST-1060-3
O-RING
1/4" MALE
QUICK CONNECT
1/4" MALE
QUICK CONNECT
CYLINDER FULL
ELECTRODE
WIRE #29
POWER
WIRE #39
POWER
WIRE #38
Maintenance
To maintain output, the water level in the cylinder will slowly
move upwards, exposing new electrode to the water as the
electrodes become coated with minerals. Eventually, all of the
usable electrode surfaces will be coated and the cylinder will be
full of water. At this point, the output will begin to drop and the red
“service” light will come on. The unit will shutdown. This indicates
the need to change the cylinder, typically 500-2000 hours of
operation, depending on the quality of the fill water supply.
To replace the cylinder
1. Drain cylinder completely using the ‘on-off- drain” switch.
2. Turn off power to the unit at the external disconnect.
Disconnect electrode power wires (#38 & #39) and
cylinder full electrode wire (#29) from the cylinder. These
connections are 1/4” quick connects. (See Figure 6B, 6C,
& 6D.)
3. Disconnect 1” hose at top of cylinder.
4. Remove cylinder, clean out the drain cup and insert the new
Figure 6A
Figure 6C
cylinder. Be sure that “o” ring is in place on the cylinder fill/
drain port prior to installation. (See Figure 6A.) New o-ring
is included with each replacement cylinder.
5. Clean and check both the fill and drain valves while servicing
the unit.
6. Check the strainer. If it is dirty or restricting the water-
replace it.
7. Install cylinder in unit by pushing downward with a slight
twisting motion, while ensuring proper orientation of cylinder
within cabinet.
8. Reconnect electrode power wires (#38 & #39) and cylinder
full electrode, wire (#29). Make sure that all electrical
connections are securely tightened. (See Figures 6B, 6C,
& 6D.)
9. Follow cold start-up instructions on page 8. Monitor amp
draw for several cycles. .
Extended Shutdown
Always drain cylinder completely if unit will be off for an extended
period of time. This will preserve the life of the cylinder.
Figure 6B
Figure 6D
