fr
anç
ais
31
30
The luminaire does not switch on automatically via the motion
sensor.
Possible causes:
•
The luminaire was switched off via push-button.
Please note:
After switching off the luminaire, motion detec-
tion only becomes active again when no people were in the de-
tection range for a longer time period than the set delay time.
•
The workstation is not completely located in the detection
range of the sensors.
Move your hand in front of the sensor and observe the lumi-
naire behaviour. If the luminaire does not respond to the
motion, realign the luminaire.
•
Sufficient daylight is available - additional artificial light is
not required.
Sommaire
Légende
Commande d’éclairage
Application et fonction
Fonctions automatiques
Fonctions manuelles
Réglages système du luminaire
Établissement d’une liaison radio
Insertion des batteries dans le dispositif de
commande manuelle
Programmation du dispositif de commande
manuelle
Création de sous-groupes de luminaires
(formation de zones)
Retrait du dispositif de commande manuelle,
fonction de réinitialisation
Recherche d’erreurs
Page
32
33-39
40-43
44-45
