english
28
29
Removing luminaires, reset function
Deleting a luminaire
To remove a luminaire from the group, proceed as follows:
•
Activate programming mode
(press “Scene 1” and “On” buttons simultaneously (see
above, page 26)).
•
Press the “Scene 1” button.
•
The “Scene 1” button and the lamp symbol light up.
•
The lamp symbol and the luminaire flash.
•
Press the “Off” button on the manual control while the lumi-
naire flashes.
•
The lamp symbol changes from flashing to continuous light-
ing.
a:
•
The luminaire dims to a minimum (removed).
b:
•
A negative confirmation tone is heard
(not removed).
•
The lamp symbol and a further luminaire start to flash.
•
Repeat this process for the other luminaires you wish to
remove.
Removing manual control, reset function
•
Open the manual control (see figure, page 25).
•
Press and hold the reset button for 3 seconds.
•
A positive confirmation tone is heard.
All information saved in the control device has been perma-
nently deleted.
Troubleshooting
The luminaire does not function.
Possible causes:
•
The luminaire was switched off via the push-button.
Switch the luminaire on.
•
The light sources are defective.
Contact
TRILUX
with defective lamps.
•
The sensor is excessively exposed to ambient light.
Cover the sensor and observe luminaire behaviour.
•
No mains power exists.
Check whether mains power is available.
The luminaire does not regulate brightness to the set nominal
value.
Possible causes:
•
Brightness control is deactivated.
Set the function selection switch to Position II.
•
Brightness control has been set to a very high nominal
value.
Set the nominal value.
•
Brightness control has been deactivated by changing the
brightness with the button.
Switch the luminaire off and on again.
AAA
-
+
AAA
-
+
AAA
+
-
reset
