english
26
27
Programming the manual control
Activating the programming mode
•
Press the “Scene 1” and “On” buttons simultaneously.
•
Keep pressing this button combination until you hear a conf
firmation signal and “Scene 1”, “Scene 2” and “Scene 3”
flash.
Note:
If no further button is pressed following the start of
programming mode this is automatically terminated by the
manual programming device after approx. 30 seconds.
Locating luminaires
•
Press the “Scene 1” button.
•
The “Scene 1” button and the lamp symbol light up.
•
The system now searches for luminaires nearby. When a
luminaire is located the lamp symbol and luminaire begin
to flash.
Adopting luminaires
Luminaires can be adopted into a group (room) or can be ig-
nored. To adopt a luminaire, proceed as follows:
•
Press the “On” button on the manual control while the lumi-
naire flashes.
•
The lamp symbol changes from flashing to continuous light-
ing.
•
A confirmation tone is heard.
•
The lamp symbol and a further luminaire start to flash.
•
Repeat this process for all luminaires you wish to adopt.
Ignoring luminaires
•
Press the “continue” button.
•
The luminaire located next and the lamp symbol start to
flash.
Terminating luminaire search
•
Press the “Scene 3” button.
Terminating programming
•
After completing the luminaire search press the “Off” button.
Creating luminaire subgroups (creating zones)
If all luminaires have been adopted into the group (room),
proceed as follows:
•
Activate programming mode
(press “Scene 1” and “On” buttons simultaneously
(see above, page 26).
•
Confirm the “Scene 2” button.
•
“Scene 2” and the lamp symbol flash.
•
One luminaire flashes. Continue with:
a:
•
Adopt luminaire with “Scene 1”.
•
A confirmation tone is heard.
b:
•
Ignore luminaire with “continue”.
•
The next luminaire flashes.
c:
•
Next subgroup with “Scene2”.
•
“Scene 2” and the lamp symbol flash.
•
One luminaire flashes.
•
Repeat this until all luminaires have been assigned.
•
Terminate programming mode (see above, page 27).
