Pack the controller on its side to allow room for the cables as shown below. Close the top flap of the
bag assembly and close the zippers so that the zipper tabs are located at the front center of the
power pack assembly. Pull the Velcro tab down over the hole in the front center of the bag.
Step
7:
Raising
the
Handlebars
Raise the handlebar riser tube by first unlocking the quick release lever. Notice that there are round
holes down the back of the handlebar riser tube providing a number of height
‐
locking positions.
holes down the back of the handlebar riser tube providing a number of height locking positions.
There is a spring loaded steel locking pin that snaps into these holes to provide a second level of
safety while riding. Push the steel pin in to release the riser tube and telescope the handlebars up to
your preferred riding height. Make sure the quick release firmly locks the telescoping steering
column in place.
If th
i k
l
i l
th
dj t
t
If the quick release is loose, use the adjustment
finger nut to tighten the quick release. Properly
adjusted, it requires a firm hand to close.
After learning how to ride, you can adjust the handlebar position
to better suit your preferred riding posture, but don’t rock them
too far back as to inhibit proper folding. You can also adjust the
Trikke Tribred Free
Rein
Owner's
Manual
V1
10/1/08
13
too far back as to inhibit proper folding. You can also adjust the
brake levers’ angle for riding comfort and ease of use.