3.1 The Controls on the Front of the Unit
OPEN
<< <
> >>
START
STOP
REPEAT
PROGRAM
TIME
1
2
3
4
5
6
7
8
9
12
10
11
Recall II
[ 1 ] CD Drawer:
Insert the CD here. The CD is to be inserted with the inscription side facing up and the
data side facing downward.
Note: Often we already observed that customers “jiggle“ at the opened drawer, in order to derive the quality from the drawer fetch.
Notice: A certain fetch must be present, so that the drawer doesn’t block itself between the opening and closing, i.e. this fetch is
necessary and intended.
[ 2 ] LED Display Title Number
This display indicates the number of titles detected on the CD. Then the actual title
number is indicated. This display expires if total play time and total remainder play time
were shown in the indicator mode.
[ 3 a ] LED Display PROGRAM
This display lights up, if you have switched on the programming mode.
(More on this mode further down)
[ 3 b ] LED Display REPEAT
This display lights up, if the repetition function was switched on with the remote control.
The entire CD will be repeated, if the programming mode isn’t programmed differently,
until the REPEAT-mode is switched off again, the rendition is stopped or the CD drawer is
opened.
[ 4 ] LED Display Title Time
This four-digit display can be adjusted with the remote control and/or the MODE-key [ 11 ]
to four different time indicator modes.
Mode 1: Already played title time, e.g. 2:45
Mode 2: Total remainder-rendering time, e.g. –63:37
Mode 3: Title remainder-rendering time, e.g. –5:23
Mode 4: Already played total rendering time, e.g. 34:52