52 Notice N°880 107 Rev A
A
A
9 - Assembly of Structure
To enable you to make sure that the distance and alignment are satisfactory, temporarily connect the
upper plates onto the main joists, using one single bolt. Lay-out the step stones without securing them,
and fit-on the lower rails.
YES
Check the spaces between the posts (side S)
and their verticality very carefully.
The levels between each one should also be
NO
checked.
Once alignment has been finished, make sure that
the diagonal distances are
the same
.
Once you have finished setting the positions, fill
the trenches with a little sand.
10 - Assembly of Lower Rails
If the pool is not positioned on a concrete slab, position a small slab measuring approximately 30 by
30 cm within the rounded parts at each point of connection of the lower rails. These slabs should be
positioned so that their upper faces are
exactly at ground level
.
Warning!
It is important that the entire length of the connection plate should lie on a flat slab. Using a
slab that is too short or failing to use a slab at all could render the installation unsatisfactory or
could cause the pool to collapse.