DISPOSAL
To dispose of the machine, take it to a demolition centre or an
authorised collection centre.
Before scrapping the machine, it is necessary to remove and separate
out the following materials, then send them to the appropriate collection
centres in accordance with the environmental hygiene regulations
currently in force:
• Brush
• Electric and electronic parts*
• Battery
• Plastic parts
• Metallic parts
(*) In particular, contact your distributor when scrapping electric and
electronic parts.
14
PROBLEM
POSSIBLE CAUSE
SOLUTION
THE MACHINE DOES NOT
CLEAN CORRECTLY
The machine does not start.
Read the section “
THE
MACHINE DOES NOT
START
”.
Not enough detergent solution
comes out.
Read the section “
NOT
ENOUGH DETERGENT
SOLUTION ON THE
BRUSH
”.
The brush is not correctly
inserted in the machine.
Insert the brush correctly in
the machine.
The brush bristles are subject
to excessive wear
Check the condition of
the brush, and replace
it if necessary (read
“
MAINTENANCE
”).
THE SQUEEGEE DOES NOT
DRY PERFECTLY
The vacuum device is
obstructed
Remove the obstructions from
the squeegee body (read
“
MAINTENANCE
”).
Remove the obstructions
from the vacuum duct (read
“
MAINTENANCE
”).
Remove the obstructions from
the recovery tank cover (read
“
MAINTENANCE
”).
EXCESSIVE FOAM
PRODUCTION
The detergent being used is
not suitable.
Check that a low foam
detergent has been used.
The floor is not very dirty.
Dilute even more the
detergent inside the solution
tank.
THE DEVICE DOES NOT
VACUUM CORRECTLY
The recovery tank is full
Empty the recovery tank (read
the chapter “
AT THE END OF
THE WORK
”).
The vacuum device is
obstructed
Read the section "
THE
SQUEEGEE DOES NOT DRY
PERFECTLY
".