4
UPON RECEIVING YOUR iON
Carefully inspect the unit to insure that it has not been damaged in shipping. In the event of
any damage, immediately contact the shipping company to report it.
The Ion 40K Micromotor comes with the following:
* Micromotor
* Control Box
* Foot Pedal
* Foot Pedal Connector
* Power Cord
* Micromotor Stand
* Chuck Tool with Allen Wrench
* Warranty Card
* Instruction Manual
INSTALLATION
Remove all items from the shipping box.
Place the Control Box on the bench in the area where it will be used.
Connect the Micromotor Cord to the round socket at the rear of the Control Box. Secure this
connection in place using the locking ring located at the end of the Micromotor Cord.
Plug the Foot Pedal Connector into the Foot Pedal. Plug the other end of the Foot Pedal
Connector into the rear of the Control Box.
Connect the Power Cord into the rear of the Control Box. Plug the other end of the Power
Cord into a properly grounded 115Volt electrical outlet.
Fit a bur into the chuck of the Micromotor. Turning the front section of the Micromotor
clockwise opens the chuck. Turning the front section of the Micromotor counter clockwise
secures the bur in place.
Summary of Contents for iON
Page 1: ...iON Micromotor Instruction Manual ...
Page 10: ...10 ...
