7
CHAPETR 2
OPERATING INSTRUCTIONS
2.
INTRODUCTION.
This chapter will list in chronological order the steps necessary to operate the TCR-HHR-02
safely and efficiently in the repeater mode. The setup and operation for a communications
system is the same with the exception of the use of the retransmission cable.
2.1. System Setup for Repeater Operation.
Refer to Figures 2-8 and 2-9 for a system block diagram of the TCR-HHR-02 in repeater
configuration.
2.1.1 Install two BB-2590 batteries and secure the battery chargers to the batteries using
the Velcro strap as illustrated in Figure 2-1.
Figure 2-1 Battery Charger Installation
2.1.2 Connect 115/230 AC or 12/24 VDC power to the appropriate connector on the
egress panel (see Figure 1-1).
2.1.3 Unlock the radio mounting bracket by pulling on the locking pin and turning ¼ turn
cw or ccw (see Figure 2-2).
Figure 2-2 Radio Mount Locking Pin
Locking Pin in
Unlocked Position