Operation Modes
Press any button but the power
button on any Infrared (IR) remote
control to turn on the switched
outlets. You may hear a click as
power is supplied to the switched
outlets. The green "switched" LED
on the top of the power strip will
illuminate.
Press power on the TV remote
control to turn on the TV.
Step 2
Step 1
ON
Use peripheral remote controls to
turn on electronics as needed.
Step 3
When finished watching TV, press
the power button on the remote
control to switch off the TV. All of the
switched outlets will automatically
turn off within 1 minute.
Step 4
OFF
Press any button except the power
button on an Infrared (IR) remote
for any of the electronics plugged
into the power strip to turn on the
switched outlets.
Press power on all music related
devices to turn them on.
If the TV is not turned on while in music mode, all switched outlets will turn
off after eight hours.
If the TV is turned on during music mode, the APS+ will switch to TV mode.
Music Mode
TV Mode
Note:
www.tricklestar.com
AV Advanced Pow
Changing the Countdown Timer
To adjust the countdown timer, press
and hold the button for 10 seconds
until the red LED illuminates. Then
press:
• Once for 30 minutes (IR + motion
sensing)
• Twice for 60 minutes (IR +
motion sensing)
• Three times for 120 minutes (IR + motion sensing, default setting)
• Four times for 60 minutes (IR-sensing only)
• Five times for 120 minutes (IR-sensing only)
After countdown timer is set, the LED will flash the number of times the
button was pressed to indicate the setting.
The sensor has a default buzzer that will sound 10 minutes and 3 minutes
prior to shutdown. To disable the buzzer, press and hold the button for 10
seconds until the red LED illuminates, then press the button six times. The
red LED will flash six times to confirm that the buzzer has been disabled.
Disabling the Buzzer
