31
Installation instruction
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever
has to be transported again.
1. After removing all the packaging, carefully
lay machine on it’s back to remove the
polystyrene base from the bottom.
2. Remove the power supply cable and the
draining hose from the hose holders on the
rear of the appliance.
3. With a suitable spanner unscrew and
remove the central rear bolt
A
.
4. Unscrew and remove the two large rear
bolts
B
and the six smaller bolts
C
.
C
C
E
D
C
C
B
B
A
5. Remove the bracket
D
, refit the six smaller
bolts
C
and slide out the relevant plastic
spacer
E
.
6. Open the porthole, take out the inlet hose
from the drum and remove the polystyrene
block fitted with on the door seal.
Attention!
7. For safety reasons, fill the smaller upper
hole and the two large ones with the
corresponding plastic plug caps supplied in
the bag containing the instruction booklet.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc.
Check that the machine does not touch the
wall or other kitchen units.
Levelling
Level the washer-dryer by raising or lowering
the feet. The feet may be tight to adjust as they
incorporate a self locking nut, but the machine
MUST be level and stable.
Any necessary adjustment can be made with a
spanner. Accurate levelling prevents vibration,
noise and displacement of the machine during
operation.
132966550.qxd 28/02/2008 13.56 Pagina 31