17
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked
.
If required, pour fabric softener into the
compartment marked
(the amount used
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by turning
the programme selector dial (1)
Turn the programme selector dial to the
required programme. The green light of button
starts to flash.
It can be turned either clockwise or
anticlockwise. On position «
O
» the programme
is reset and the machine is switched OFF.
At the end of the programme the selector
dial must be turned to position
«
O
»
, to
switch the machine off.
IMPORTANT!
If you turn the programme selector dial to
another programme when the machine is
working, the
red
light of the button
flashes
3 times and the message
Err
is displayed on
the display to indicate a wrong selection. The
machine will NOT perform the new selected
programme.
Select the spin speed or the Rinse Hold
option by pressing button
When selecting a programme, the light
corresponding to the maximum speed allowed
for that programme will illuminate (refer to the
section
«Programme table»
for the maximum
allowed spin speed).
Select the degree of dryness or the duration
of the drying cycle by pressing buttons
and
4
3
2
8
8
By pressing button
it is possible to select
an automatic degree of dryness for cotton or
synthetics items. The washer dryer will
automatically adjust the duration of the drying
cycle to the selected degree. The relevant light
illuminates.
Also, the button
allows you to select a
drying time for
Cottons
and
Synthetics
from
10 minutes to 130 minutes (
2.10
). Every time
you press this button the time increases by 5
mins.
Select the desired option by pressing
buttons and
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired programme
and before depressing the button
8
.
For the compatibility of the options with the
washing programmes, refer to the section
«Programme table».
Select the delayed start by pressing the
button
Press this button to select the required delay.
The selected delay time value will appear on
the display for a few seconds, then the duration
of the programme will appear again.
You must select this option after you have set
the programme and before you press button
.
You can cancel the delay time at any moment,
before you press button
.
If you have already pressed it
, and you wish
to cancel the delay time, proceed as follows:
• set the machine to PAUSE by pressing button
;
• press button
once. On the display will
appear the symbol «
0’
».
• press button
again to start the
programme.
8
10
8
8
8
10
6
5
4
3
132966550.qxd 28/02/2008 13.56 Pagina 17