20
Autodrying (NON-STOP programme)
At the end of the drying cycle, the buzzer
sounds. A flashing zero «
0
» appears on the
display.
At this point of the programme, starts an anti-
crease phase which lasts about 10 minutes.
During this time the door is locked and the dis-
play keeps showing the flashing zero
«
0
».
(If you whish to open the door before or during
the anti-crease phase, please follow the
instructions given in the previous chapter).
7. Turn the selector dial to the «
O
» position to
switch the machine off.
8. Remove the laundry.
Warning!
For NON-STOP programmes, it is essential not
to exceed the maximum load sizes of 3 kg for
cotton and 2 kg for synthetics.
Do not use a dosing device/ball when carry-
ing out a washing & drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the
selector dial to the selected wash pro-
gramme/fabric.
4.
Select the required options by pressing the
relevant buttons.
Warning!
If possible, do not select a spin speed lower
than that proposed by the appliance to avoid a
too long drying time so saving energy.
In any case the reduction of the spin speed is
only possible after selecting drying.
The lowest value
with automatic drying
for
cottons and synthetics is 900 r.p.m. .
The lowest value
with timed drying
you can
select for synthetics is 700 r.p.m.
5. Select the drying time or a dryness degree
by pressing buttons
or
(see the
drying programmes). The display shows
the entire duration of the washing and the
selected drying cycle.
6. Start the programme by pressing button
. After the programme has started, the
time remaining on the display is updated
every minute.
8
4
3
132966550.qxd 28/02/2008 13.56 Pagina 20