24
MOVING YOUR APPLIANCE
You may damage some soft or badly fitted floor
coverings when you move the appliance. The floor
covering under the appliance should be securely
fixed so it does not ruck up when you move the
appliance across it. Alternatively you could remove
the floor covering. This appliance is heavy and care
must be taken when moving it.
Do not
try to move
the appliance by pulling the door handles.
To move the appliance open the grill door. Raise
the appliance off its front feet by lifting it from inside
the oven. Pull the appliance forward. When you
replace the appliance push it back to the stop and
make sure there is the same gap at each rear
corner.
FOR YOUR SAFETY
Do not
try to disconnect the appliance from the gas
supply if the supply pipe does not have a bayonet
connection, as described in the installation
instructions. If this is the case contact the person
who installed the appliance.
LOCATION OF APPLIANCE
This appliance must not be installed in a bed-sitting
room of volume less than 20m
3
or in a bathroom,
shower room or garage. It is essential that the
appliance is positioned as Fig.1. The appliance
must be a minimum of 20mm from the rear wall
(note that this dimension is provide by the inlet
elbow). Shelves, wall cabinets and cooker hoods
must not be fitted closer than 500mm to the top of
the grill canopy or within 100mm of the sides of the
grill. Curtains must not be fitted immediately behind
the appliance or within 200mm of the sides of the
grill. If fitted next to or between two base units a
minimum space of 1mm must be left between each
unit and the sides of the appliance. The hotplate
must be set to a minimum of 7mm above the
adjacent units (note that the levelling feet fitted to the
appliance will achieve a nominal height to hotplate
level of 907mm -5+13mm. Base units not meeting
the above conditions must be a minimum of 100mm
away from the hotplate.
Note: -
L.P.G. cookers MUST NOT be installed
below ground level i.e. in a basement or aboard any
boat, yacht or other vessel.
LEVELLING THE APPLIANCE
Adjustment to suit floor conditions or height is
obtained by rotating clockwise or anti clockwise the
feet at the front and rear of the appliance. A spirit
level should be placed on one of the shelves to
confirm the appliance is correctly levelled.
Fig.1
