Operating the receiver
9
Channel list sorting
In the last step of the initial installation you are asked, if the
channels which are found during the channel search, should be
sorted automatically.
Note:
This function is only effective, if accordant channel
list informations are sent by the broadcast-station.
Use the buttons
or
to select
“manually” or “automatically” and confirm with
OK
.
Manually:
Channel list remains unchanged
Automatically:
Channel list is sorted automatically
The menu for automatic channel search and the search process will be started. During the
search the window shows Status: “scanning”. The newly found TV and radio programmes will
be listed. Once the search is complete,
the message Status: “complete” is shown.
Use
EXIT
to leave the search menu.
Operating the receiver
Switching receiver ON/OFF
1.) This receiver is equipped with a low power standby circuit.
If this function is activated, the standby power consumption of the receiver is less
than 1W.
The function is switched ON or OFF in the menu SETTINGS/RECEIVER SETUP.
Low-Power Standby ON
– Switching on the receiver takes about 10 seconds
(Display: “boot”).
Low-Power Standby OFF
– Receiver switches ON immediately.
2.) The receiver is also equipped with the funct
ion „
Auto-Standby
“.
This function can be activated or deactivated in the menu SETTINGS/RECEIVER
SETUP.
If “Auto-Standby“ is activated, the receiver switches to Standby-Mode after 3 hours
running. Precondition: No timer is activated and no operations with the remote control
during this time.
You can switch on the receiver by pressing
,
OK
,
or by using one of the numeric
buttons
1…0
. The last activated channel will be displayed (e.g. 0015).
The digital receiver is switched into standby mode by pressing
.
ATTENTION:
Only by pulling the mains adapter the receiver is disconnected from the
power supply completely.
Welcome
Channel list sorting
manually
automatically
