9
Operating the Unit
Turning the Unit On/Off
Press the Power Button on the Control Panel or Remote
to turn the unit on. The unit will initially be set to
Normal Mode. Press the Power Button once more to
turn the power off.
Using Normal Mode
Press Normal/High button until “Normal” is shown in
the lower right of the Display.
• Square Footage not available in “Normal”
(see “INITIAL SETUP: Initial Settings” page 8).
• To control the fan speed: Use Fan Up/Down buttons.
Using High Mode
Press the Normal/High button and verify that “High” is
shown in the lower right of the Display.
• To set the square footage on the Display:
• Use Purifier Up/Down buttons (see INITIAL SETUP:
Initial Settings” page 8).
• To control the fan speed: Use Fan Up/Down buttons.
CAUTION:
Never adjust setting to exceed square
footage of ventilated space being treated.
Using Sani+Booster
Press the Sani+Booster button and verify that “Away”
is shown in the lower right of the Display.
• To set the Sani+Booster Timer: press the Sani+Booster
button. Each press of the Sani+Booster button
increases the running time of the Sani+Booster.
• Select
0:30,
1:00,
or
2:00
hours.
Press Sani+Booster once more to switch the
unit back to Normal Mode.
Operations
LCD Reminders
Replace Plate
When “Replace Plate” appears, the Purification Plate has
reached the end of its useful life and must be replaced.
To order a replacement, contact your distributor. Once
a replacement has been obtained, follow the instructions
in “DISASSEMBLY/ASSEMBLY” (pages 10-11) to
replace your old Purification Plate with your new one.
Replace PCO Cell
When “Replace PCO Cell” appears, the PCO Cell
has reached the end of its useful life and must
be replaced. Contact your distributor to order a
replacement. Once a replacement has been obtained,
follow the instructions in “DISASSEMBLY/
ASSEMBLY” (pages 10-11) to replace your old
PCO Cell with your new one.
Perform Cleaning
“Perform Cleaning” will display once the 30 day
operation cycle between cleanings has passed and the unit
requires a complete cleaning. Follow the instructions in
“CLEANING” (page 12) then see “Resetting Reminders”
(below) to reset the reminders. The Perform Cleaning
reminder will appear again after 30 day of operation.
Resetting Reminders
After replacing the Purification Plate or the PCO Cell,
the corresponding reminders will reset themselves. After
performing a cleaning of the unit (see “CLEANING” page
12) you should reset the reminders by holding down the
Reminder Reset button on the Control Panel of the unit.
The reminder has been reset when Perform Cleaning no
longer appears.
Summary of Contents for air purifier system
Page 14: ...14 Triad Aer 2012 All Rights Reserved Notes...
Page 15: ...15 Notes...
