9
HF 1900 BT
ENGLISH
BUTTONS AND CONTROLS
1. MEM/CLK SET, PROG, S e t clock timer, CD program playback
and radio memory.
2.
button, set the unit to ON/STANDBY.
3. SOURCE button, select BLUETOOTH, CD, FM or AUX function.
4.
9
/TUN-, Skip tracks backward in CD mode. Adjusts the
frequency in FM mode.
5. MEM-/10-, choose the preset location for the corresponding
station.
6.
/PAIRING, Pause and resume playback or pairing
Bluetooth device.
7. EJECT/ENTER, in CD mode, eject and close CD tray.
8. REPEAT, Set playback to repeat.
9.
:
/TUN+, Skip tracks forward in CD mode. Adjusts the
frequency in FM mode.
10. MEM+/10+, choose the preset location for the correspon-
ding station.
11. , Stop playback.
12. & 13. Tasto VOL-, adjust the volume level.
14. & 15. /-, Adjust folders forward or
backward in CD or USB mode.
REMOTE CONTROL
SAFETY INSTRUCTION
This device is an electronic precision instrument; so avoid using it in the following cases:
• Near sources of heat such as heaters and stoves.
• In very humid places such as bathrooms, swimming pools, etc.
• In dusty places.
• In places subject to strong vibrations.
• Place the device so that its sides there is always enough space for the free movement of air (at least 5 cm).
• Do not block the vents.
• If liquids penetrate inside the device immediately disconnect the plug and bring the unit to your nearest authorized TREVI assi-
stance.
• Always check before turning on the device that the power and connection cables are installed correctly.
CAUTIONS ON LASER
This device is equipped with a reading system with laser beam. Although the laser is low power, and with a
safety device that prevents it from operating when the door opened always adhere to the following warnings:
- Do not approach the eye to the laser lens with the device opened, the danger of damage to the retina.
- Do not attempt to dismantle or tamper with the laser unit, danger of radiation absorption.
TO ACTIVATE THE REMOTE CONRTOL AND BATTERY REPLACEMENT
The remote control comes with a cell battery already installed. To activate the
battery, remove the transparent tab at the bottom of the remote control. The remote
control is now ready to use.
To Replace With a New Battery:
1. Remove the battery compartment cover as per the illustration on the right.
2. Observe the correct polarity and install a 3V
lithium battery (CR2025).
3. Close the cover.
With earphone or headphones use:
To prevent possible hearing damage, limit the amount of time listening at high volumes.
