UPRIGHT POST TOP PLATE INSTALLATION
9
TOP SEAT INSTALLATION
10
Put the top plate on the upper side of the upright, and secure with
two (2) screws “Z” on each side.
SCREW ‘’Z’’
TOP
PLATE
UPRIGHT
Be sure to have a vertical (plumb) upright before fixing the top seat.
Place the top seat on the upper side of the upright.
Center the top seat between the two uprights and secure with four
(4) screws “Z”.
SCREW ‘’Z’’
SEAT CAP, OPTIONAL LIGHTING
11
Optional lighting
: Pass the sensor wire through the hole on top of
the seat cap and hold it in place with the plastic frame.
Connect the two wires together and place the battery case in the
lens housing. Install all in the cap extension.
Without lighting:
Slide the lens inside the round section cap
extension
ROUND SECTION
CAP EXTENSION
LENS
