SEAT CAP INSTALLATION
12
SECURITY LABELS INSTALLATION
13
Install the four (4) safety labels (DANGER) supplied with your pool
as follows: two (2) labels visible at the entrance to the pool and two
(2) visible at the main access of the backyard.
Important:
if you require additional labels, please contact us at
Trevipools.com
Install a minimum of three (3) safety labels (supplied with the liner)
inside the pool so that at least one label is visible no matter where
the bather enters the water (see drawing for positionning)
LABEL
Hook the base of the lens previously attached to the round section
cap extension in the slot on the front of the upright. Secure the cap
extension it in place on the upright with two (2) screws ‘’Z’’ on each
side. (Illustration 14.1)
Then place the seat cap on the inside edge of the seats and snap it
to the top of the cap extension. (Illustration 14.2)
Secure the seat cap with two (2) screws no6 flat head x 3/8 in.
Install the plastic cap on the seat cap. (Illustration 14.3)
SCREW ‘
’
Z
’’
SCREW # 6 x 3/8
SEAT CAP
Illustration 14.3
Illustration 14.2
Illustration 14.1
