TBS-800
4536
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel/fax:+48 58 56 300 80 www,ega.com.pl
9
Fig.5 Fig.6
Operation
Using the belt sander
Hold the machine with both hands and assume a balanced posture. Press the On/Off trigger
switch and allow the motor to reach full speed. Hold the machine parallel to the work piece.
Gently bring belt contact with the work piece.
Caution!
The sander may initially snatch forwards. Resist the forwards motion and allow
the sander to move forwards at a gradual pace. Do not use excessive, downward pressure,
this may cause the belt to snap. Keep the sander moving forwards at an even pace. Failure
to do this will result in an uneven finish. When the operation finished, lift the sander clear of
the workpiece and release the On/Off trigger switch. Wait until the belt has stopped rotating
before putting the sander down on workbench. Failure to do this will result in the machine
running forwards.
Replacing the sanding belts
Locate the belt tension lever (Fig.7)and pull outwards. Take care as the lever is under
tension and may spring back to the closed position. Continue pulling the lever outwards until
it locks in the position shown in Fig.7.
Fig.7
Summary of Contents for 4536
Page 2: ......
