Trendteam MATS 1976-670-D4, Installation Instructions Manual

Page: 7 / 33

Dear valued customer,
Thank you for purchasing furniture from our interior programme, exclusively for use in private rooms. Please check the delivery for
completeness, carefully read the following important information prior to assembly and retain it for future use, also by third parties.
Our furniture may only be used as intended. Improper use can cause damage to property, or personal injury under certain circumstances.
Furniture is not a toy. The manufacturer or distributor assumes no liability for damage caused by unintended use or improper handling.
ATTENTION: Children or persons with a mental disability must be kept away from furniture components, sharp objects, small parts and
packaging materials at all times. There is a risk of injury and/or suffocation.
ASSEMBLY: Please observe our operating, assembly or installation instructions for assembly and observe the warnings and safety
instructions in particular. Failure to follow instructions may lead to personal injury or damage to the furniture, and can pose a safety risk.
Please contact our service team if you have problems with setup/assembly. They will be happy to help you. Assembly may only be carried
out by competent persons. No liability for damage is assumed in case of changes to the product/product components or the
replacement/use of parts/consumables not provided by the manufacturer/distributor.
If wall mounting materials such as dowels or screws are included with the product, these are intended exclusively for use on solid walls
made of uniform materials. Attachment is only as good as the connection between the mounting materials and the wall. For both standing
and hanging furniture, check your wall for suitability prior to attachment and only use suitable mounting materials. Ensure there are no
lines in the drilling zone before drilling any holes. Ultimately, the installer is responsible for the attachment to the wall.
This also applies to the installation of electrical appliances and other structural accessories. The assembly/installation of electrical
appliances and other structural accessories must be performed exclusively by authorised, qualified personnel. All electrical and structural
installations must be carried out according to the respective applicable standards and safety regulations in your federal state. Only use
approved illuminants for light sources. There is a risk of overheating and fire if the maximum wattage is exceeded. Covering illuminants is
prohibited due to the risk of fire.
Proper functioning of the furniture requires plumb and horizontal alignment. The doors are pre-adjusted, but may have to be readjusted
due to local conditions. Be sure to observe the weight specifications for maximum loads. Climbing on furniture is prohibited. Furniture may
tip over in case of improper use. To prevent this, furniture should always be secured against tipping over. There is a risk of breakage and
injury in case of overloading (in particular by playing children, people, materials or other prohibited loads). All screws and load-bearing
connections should be re-tightened after 5 to 6 weeks to ensure permanent stability.
CARE:
- Notes on furniture care -
Please observe our information on proper furniture care to ensure you can enjoy our product for a long time.
Use a clean, dry, soft cotton cloth for cleaning. If your furniture is heavily soiled, you may moisten the cloth with some water or furniture
cleaner and dry the cleaned elements afterwards. Metal and glass components are best cleaned with conventional metal and glass cleaners
according to the instructions provided for them. The cleaning agents must be clearly identified as being suitable for furniture care.
Do not use steam cleaners, corrosive, scouring cleaning agents or other cleaners with unknown effects under any circumstances.
ATTENTION: High-gloss surfaces are covered by a protective film on delivery. Leave this on the furniture until it has been fully assembled
and dusted. Once the protective film is removed, high-gloss elements may only be cleaned and used after 72 hours (time for post-curing in
room air).
Do not damage surfaces with sharp objects and never expose them to strong sunlight.
DISPOSAL
- Notes on waste disposal -
For the good of the environment, please sort the packaging for disposal, use the waste/recycling bins provided and do not litter.
Damaged or unusable furniture can be recycled by special facilities for the recycling of components.
Disused furniture that is still functional does not have to be discarded. Consider donating it to a charitable organisation.
We hope you enjoy your new furniture.
EN