Figure 2: Wireless Print Server Screen
3. Click
Next
on the first screen of the Wizard, to view a list of Wireless Print Servers on
your LAN.
4. Select your new Wireless Print Server, then click
Next
to continue.
5. Enter the required data on the following screen.
•
Name of the Print Server can be changed if you wish.
•
Comment is optional.
•
Select or enter the Workgroup name for this Wireless Print Server.
6. Click
Next
to configure the
TCP/IP Screen
:
•
Select
Obtain IP Address automatically
if your LAN has a DHCP Server, otherwise
select
Fixed IP Address
.
•
For
Fixed IP Address
, enter an unused address from the range used on your LAN, or
click the
Suggest New Values
Button.
Use the same
Network Mask
and
Gateway
as PCs on your LAN.
7. On
the
Wireless Screens
, the settings should be set to match your other Wireless Stations.
For details about each setting, refer to the following section
Wireless Configuration
.
8. Click
Finish
to save the data to the Wireless Print Server.
Note: To install the Wizard on your PC, use the "Installation" option.
If the desired Wireless Print Server is not listed:
•
Check all cables to the Wireless Print Server.
•
Check the Wireless Print Server's LEDs:
•
The Red LED should be OFF and the Green LED should be ON or flashing.
•
Check the LAN and WLAN LEDs. Both should be On (if a LAN cable is connected).
•
Check that your PC and the Wireless Print Server are on the same LAN segment. (If
you don't have a Router or Gateway on your LAN, you only have 1 segment.)
•
If using the Wireless connection, ensure that your PC's Wireless settings match the
Print Server.
•
Check that your PC has either the TCP/IP or NetBEUI network protocols installed. See
Checking your Network Protocols
on page 10 for details.
Page 7
Summary of Contents for TEW-P1U1P
Page 1: ......