© Copyright 2012 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-652BRU
39
Enable dynamic routing on your router
Routing > Dynamic
You may want set up your router to route computers or devices on your network to
other local networks through other routers. If other routers support dynamic routing
such as RIP (Routing Information Protocol), you can enable this feature on your router
to automatically learn the required routes to reach those networks. It is required that
the same dynamic routing protocol and version is also enabled on the other routers in
order your router and the other routers to exchange information about the network.
Note:
Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see “Access your router management page”
on
page 26
).
2. Click on
Routing
, and click on
Dynamic
.
3. Select the appropriate dynamic routing protocol and version communicate with other
routers.
•
Transmit
– Allows your router to send out network information to other
routers so other routers can dynamically build routes to your network.
o
Disabled
– Disable sending routing information from your router to
other routers.
o
RIP 1
- Sends out routing information to other routers using the RIP
version 1 protocol.
o
RIP 2
– Sends out routing information to other routers using the RIP
version 2 protocol.
•
Receive
- Allows your router to receive network information from other router
so your router can build routes to other networks.
o
Disabled
– Disable receiving routing information from other routers to
your router.
o
RIP 1
- Receive routing information from other routers using the RIP
version 1 protocol.
o
RIP 2
– Receive routing information from other routers using the RIP
version 2 protocol.
4. Click
Apply
to save the changes or click
Cancel
to discard the changes.
Summary of Contents for TEW-652BRU
Page 1: ...TRENDnet User s Guide Cover Page...
Page 70: ......
