© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet
User’s Guide
TEG-7080ES
27
Troubleshooting
Q: I typed
in my Internet Browser Address Bar, but an error
message says “The page cannot be displayed.” How can I access the
switch
management page?
Answer:
1. Check your hardware settings again. See “
page 4.
2. Make sure the Power and port Link/Activity and WLAN lights are lit.
3. Make sure your network adapter TCP/IP settings are set to
Use the following IP
address or Static IP
(see the steps below).
4. Make sure your computer is connected to one of the Ethernet switch ports.
5. Since the switch default IP address is 192.168.10.200, make sure there are no other
network devices assigned an IP address of 192.168.10.200
Windows 7/8.1/10
a. Go into the
Control Panel
, click
Network and Sharing Center
.
b. Click
Change Adapter Settings
, right-click the
Local Area Connection
icon.
c. Then click
Properties
and click
Internet Protocol Version 4 (TCP/IPv4)
.
d. Then click
Use the following IP address,
and make sure to assign your
network adapter an IP address in the subnet of 192.168.10.x. Click
OK
Windows Vista
a. Go into the
Control Panel
, click
Network and Internet
.
b. Click
Manage Network Connections,
right-click the
Local Area Connection
icon and click
Properties
.
c. Click
Internet Protocol Version (TCP/IPv4)
and then click
Properties
.
d. Then click
Use the following IP address,
and make sure to assign your
network adapter an IP address in the subnet of 192.168.10.x. Click
OK
Windows XP/2000
a. Go into the
Control Panel
, double-click the
Network Connections
icon
b. Right-click the
Local Area Connection
icon and the click
Properties
.
c. Click
Internet Protocol (TCP/IP)
and click
Properties
.
d. Then click
Use the following IP address,
and make sure to assign your
network adapter an IP address in the subnet of 192.168.10.x. Click
OK
Note:
If you are experiencing difficulties, please contact your computer or operating
system manufacturer for assistance.
Q:
If my switch IP address is different than my network’s subnet, what should I do?
Answer:
You should still configure the switch first. After all the settings are applied, go to the
switch configuration page, click on System, click IPv4 Setup and change the IP address of
the switch to be within your network’s IP subnet. Click Apply, then click OK. Then click
Save Settings to Flash (menu) and click Save Settings to Flash to save the IP settings to
the NV-RAM.
Q: I changed the IP address of the switch, but I forgot it. How do I reset my switch?
Answer:
Using a paper clip, push and hold the reset button on the front of the switch and release
after 15 seconds.
The default IP address of the switch is 192.168.10.200. The default user name and
password is “admin”.