Standard Operating Procedure
Attraction: EUROBUNGY-TRAMPOLINE
August
2011
Policy: Standard Operating Procedures Manual
Approved: Peter Raidt
Page 10 of 39
The proper amount of elastics fitting the jumpers weight have to be connected . The
leftovers hang down on the Carabiners which connect the jumper rope to the elastics
The jumper is to stand up in front of the harness.
Place the top strap above the hips of the jumper. This strap is to sit low on the waist of
the jumper as possible.
Close the buckle by putting one end into the other end of the buckle (like in a car seat),
make sure the mechanism “locked”.
Tighten the strap around the hip, don’t tighten too much, check the jumper feels
comfortable.
The carabiners (safe snap links) should be on the outside and above the hips of the
jumper.
If you cannot close the strap completely, use a smaller harness or open the strap in the
back
Put the leg straps around the legs. A rough general adjustment of these straps should
occur
before feeding the strap in between the legs of the jumper.
Close the buckle and make sure it’s locked.
Tighten the strap around the leg and check the jumpers’ comfort.
Assure that the leashes where the elastics are hanging into are right on the sides of the
hips ! If they are not positioned right and left, readjust the harness.
If the jumper does not fit in any of the harnesses,
do not use the EUROBUNGY-TRAMPOLINE !!
The harness should fit the jumper tightly, but not so tightly that it is uncomfortable. The harness
straps should rest comfortably at the top of the thighs and around the buttocks. Make sure that
the clothing of the jumper is not bunched or gathered beneath the straps.
The instructor should ask the jumper how the harness feels and make sure that the
jumper is comfortable and confident in the harness
.
The jumper should be told to voice any concerns with the harness and or his/her comfort at ANY
time during their time on the “EUROBUNGY-TRAMPOLINE”. Should the harness become
uncomfortable for the jumper during their time, instruct the jumper to stop their movement and
lower the hoist down so the instructor can fix the harness.
During any time working on the harness, the instructor is to be aware of keeping his or her
hands clear of the jumper’s genital area.
HARNESS MAINTENANCE & STORAGE
-
Don’t use warmer water than 30 degrees Celsius for cleaning. Use regular laundry soap
and clear water to wash it out
-
Neither store the harnesses in the direct sun light nor use the direct sun light to dry wet
harnesses. Use a fan or well air circulated area for storage and drying process
-
Don’t use any sharp tools to use with the harness
-
Max temperature are 40 below and 80 above zero Degrees Celsius
Important Notice: specific training is essential before use
