EN
18
Enabling/Disabling the Wi-Fi Function
Press and hold "WiFi/WPS" until
WIFI
is displayed on the screen. When
WIFI
is displayed, it
indicates that the Wi-Fi function is enabled.
i
Press and hold "WiFi/WPS" until
WIFI
disappears. When
WIFI
disappears, it indicates that the
Wi-Fi is disabled.
Establishing a WPS Connection
If the Wi-Fi clients connected to the Portable WLAN HotSpot support the WPS function, the
Portable WLAN HotSpot can generate a network key without manual input. To establish a WPS
connection, please proceed as follows:
a) Power on the Portable WLAN HotSpot.
b) Start the clients connected to the Portable WLAN HotSpot.
c) Enable the WPS function of the Portable WLAN HotSpot.
i
By pressing and holding "WiFi/WPS", you can enable the WPS function of the Portable
WLAN HotSpot.
d) Enable the WPS function of the clients.
i
For the Wi-Fi operations of the clients, see the clients’ user guide.
Restoring the Factory Defaults
If you forget the changes of some parameter settings, you can restore them to factory defaults
and reconfigure the parameters of the Portable WLAN HotSpot.
Press and hold "WiFi/WPS" and "CONNECT" at the same time until the screen is off. Then you
restore the factory defaults.
i
After factory defaults are restored, all personal configuration settings are deleted and all
web-based management settings and parameters are restored to their default values.
Tips:
If you cannot use the Portable WLAN HotSpot properly, you can try the following:
See "Help" on the "Web management" page.
•
Restart the Portable WLAN HotSpot.
•
Restore the factory defaults.
•
Contact your dealer.
•
