5. Open the cover (5) of the mixing container (8) and allow the remaining dough to dry for a couple of
hours, if necessary, overnight.
6. After the dough is fully dry, you may brush out the appliance.
7. Dismantle the pasta machine in accordance with the dismantling instructions.
8. Place the attachments into the dishwasher (*please read the instructions on the first page) or wash
them by hand in hot water using a washing solution.
ATTENTION: Never immerse the motor casing (1) in water.
9. Wipe down the motor casing only with a slightly moist piece of cloth.
10. Carefully dry all the components and again switch on the appliance according to the installation
instructions.
ATTENTION
-
Do not install the machine in wet locations or where there is exposure to steam.
-
Never immerse the motor casing of the mains cable into the water.
-
If there are children present at the workplace, the supervision of adults is necessary.
-
Always remove the plug from the socket outlet during cleaning, dismantling or installing appliance
components, or if the pasta machine is not in use.
-
Do not let the power cable touch hot surfaces.
-
Only use the pasta machine when the cover is closed.
-
First switch off the equipment and wait until the dough mixture has stopped before you remove the
cover.
-
Never touch moving parts.
-
Do not use the appliance if it is damaged or if the power cable is damaged. Send it to our Service
department to reduce risks. With this type of appliance, a damaged cable should only be replaced by
our service department using special tools.
-
Only use original components and accessories.
-
Never use the pasta machine outdoors.
-
The pasta machine is intended for home use and not for professional use.
CE
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are colored in accordance with the following code:
BLUE
NEUTRAL
BROWN
LIVE
GREEN/YELLOW
EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured red.
The wire which is coloured GREEN/YELLOW must be connected to the terminal which is marked with
the letter E or
and is coloured GREEN or GREEN/YELLOW
WARNING: THIS APPLIANCE MUST BE EARTHED
