4
5. Insert the search coil cable plug into the five pin jack on the back
control box’s housing.
6. Lengthen or shorten the stem, so when you stand upright with the
detector in your hand, the search coil is level with and about 1~5cm
above the ground. After that tighten the lock nut.
Caution:
The search coil cable plug fits into the connector only one way. Do
not force the plug or you could damage it.
You don’t need to disassemble the stem lock nut. In case you
disassemble it carelessly, place the washer on the top of the stem
connected with the handle with the small head of the washer
upwards. Then hitch the stem lock nut on the washer then tighten it
to lock it in place.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil’s end, then adjust the search coil to
the desired angle. (The search coil should be parallel with the ground.)
Tighten the knobs just enough to keep the search coil from rotating or
wobbling.
