37
•
(2) Plastic Spacers
•
(1) Trip Lever
•
(5) 6-32 set screws
•
(2) connection wires with spade connectors
•
(1) section of heat shrink tubing for the DB-15 Connection
•
(2) zip ties
•
Disconnect machine from power and allow to cool to prevent contact with hot
machine parts.
•
Disconnect air supply to prevent unwanted machine movement
•
Remove guide plate by loosening side plate bolts. Most machines will have four of
these bolts.
•
Stand machine up on outfeed side.
•
Remove jack screws and nuts from DB-15 connector.
•
Cut off zip tie and heat shrunk insulator from connector - be careful not to cut wires!
•
Solder supplied wires to pins 5 and 12 of connector, taking care not to solder bridge any
connections.
•
Re-install heat shrink tubing. Heat the top portion first (closest to connector) and secure
with zip tie. Heat shrink lower part and trim.
•
Re-install DB-15 connector in back plate and secure with jack screws and nuts.
•
Re-orient the machine so it is sitting in its normal configuration with bottom plate down.
Looking at the infeed side, through the hole where the guide plate was, two small 6-32
threaded holes will be visible on the right inside plate of the machine. These are the
holes for the 6-32 bolts that will hold the micro switch on the right-side plate. The switch
should be installed with switch lever facing up and tip pointing to the front of the
machine.
•
Install supplied wires to bottom 2 spade lugs of trip switch.
•
Locate the holes for the ¼” pivot shaft
(figure 23). These holes may need to be reamed
to clean out residue or paint. Verify fit before attempting next step.
Summary of Contents for 1000 4.5 Hot cutter
