www.traxontechnologies.com | www.osram.us/traxon
©2022 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS, OTHER PATENTS
PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Installation Guide
V1.0 04/22
P. 10 of 21
3.2 Pre-Installation Checks
3.2.1
Installation Checklist
1. Prepare cables and all necessary accessories (Waterproof Quick Lock End Caps etc).
2. Perform functional check of the Media Tube
®
Go. Take care not to damage cables/connectors during pre-
installation checks.
3. Ensure all pre-installation checks laid out below have been followed.
4. Mount the Media Tube
®
Go on-site. If the installation is to be left uncompleted overnight, place all non-
connected LED Engines and the Media Tube
®
Go in an indoor environment.
5. All units must be connected or utilize end caps to protect from water ingress.
Ensure all the Interconnection Cables, Media Tube
®
Go and LED Engines are initially stored in a dry area to
guarantee the complete sealing of the system from water before installation.
3.2.2
Mounting Bracket
Mounting hardware (screws, lock washers and washers) are required for mounting the bracket to the surface.
Mounting hardware by others. The mounting brackets can be moved along the extrusion to match installation
requirements.
FIG.6: Mounting Bracket
Mounting Hardware
(by others)
φ
4.5mm/0.18’’
40mm/1.57”
24mm/0.94”
3.2.3
Installation Sequence
1. Measure the correct distances for brackets and install the Media Tube
®
Go fixtures.
2. Connect the Media Tube
®
Go in the daisy-chain manner outlined in the System Diagram to form large
installations.
3. Perform functional check on all the Media Tube
®
Go and inspect cables and brackets for any damage. Check
for any abnormalities with the control signal.
4. Report any functional defect found to your nearest Traxon Technologies office. DO NOT attempt to install the
Media Tube
®
Go with functional defects on-site.
