Gas/Pellet Remote Thermostat
SKU 99300689
Page 2 of 8
3/7/12 - 17601682
© Travis Industries, Inc.
Gas or Pellet Stove Receiver Placement
Place the receiver below the stove, preferably on the pedestal (if applicable) or on the stove under-tray, away from
any hot surfaces. Two pieces of hook and loop tape are provided to allow you to secure the receiver if needed.
When placing the receiver, position it with the button in an accessible position to allow for remote over-ride. Route the
receiver wires to a location near the on/off switch (making sure all wiring is kept away from hot or moving
components). Connect the receiver power cord to a 110 VAC outlet (on newer gas stoves you may use the power
cord adapter - see “Power Cord Adapter Installation” for details).
Place the receiver below the stove
(on the pedestal or undertray).
Route the wires to the
on/off switch.
Hook and Loop Tape
Gas or Pellet Fireplace Insert Receiver Placement
Place the receiver behind the surround panel on the fireplace floor (see the illustration to the right). Route the
receiver wires to a location near the on/off switch.
Connect the receiver power cord to a 110 VAC outlet.
NOTE
: On the 31 and 33 DVI you may use the power cord adapter to connect the power cord directly to the insert.
See “Power Cord Adapter Installation” for details.
Place the receiver on the right side
floor of the firebox, as far away from
the insert as possible (minimum 1"
clearance to side of insert).
