Finalizing
the
Installation
(qualified installers only)
25
© Travis Industries, Inc.
4/11/22 - 1538
Outdoor Linear Burners
Steps for Finalizing the Installation
1. If using propane (LP) gas, convert the appliance (prior to installing the crushed glass).
2. We recommend you purge the gas line at this time.
3. Leak test all gas joints.
4. Install the burner (if removed for converting to LP gas).
5. Test burn the appliance
6. Apply finish material to the enclosure.
7. Assemble the Windbreak Glass (do not install the Windbreak until the last step).
8. Install the crushed glass, Lava Rock, or Tumbled Stone media.
9. Install the Glass Windbreak(s)
Crushed Glass Installation
Crushed glass is placed over the burners and center media trays. Use only ¼” crushed glass from Travis
Industries and/or other media specifically approved by Travis Industries.
Placing Crushed Glass on the Burner and Center Media Trays
Glass Quantity
Needed
36" Linear Burner
10 lbs. (4.54 kg)
60" Linear Burner
25 lbs. (11.34 kg)
120" Linear Burner
50 lbs. (22.64 kg)
1 Level Cup (8 fl. oz.) (240ml) = 0.95 lbs.
So...1 Slightly Rounded Cup = 1 lb.
Determine the amount of glass needed for the linear burner being installed. Set this glass aside in portions to
allow for an even amount of glass to be placed over the surface of the burner and media tray.
NOTE:
It is better
to install too little glass than too much.
(a) Open up a bag of crushed glass and pour it evenly onto the burner and media trays. Use a brush or glove to
evenly distribute the glass over the surface.
(b) Spread an even layer of crushed glass over the media tray and burner. The glass must be only (1) layer thick
on the burner but can be (2) layers thick on the media tray. Excessive glass placed on the burner may cause
poor burn characteristics and can lead to sooting and/or delayed ignitions.
(1)
layer thick
on burner
(2)
layers thick
on media tray
