20
Operation
© Travis Industries
4030407
100-01146
Before You Begin
!
Read this entire manual before you use your new fountain, especially the section "Safety Precautions" on pages 4 & 5. Failure to
follow the instructions may result in property damage, bodily injury, or even death.
!
Remove any cover from the fountain. Inspect for debris or objects that may have fallen into the fountain.
!
Check for any damage to fountain or its supply lines.
!
Check the water level in the tank. Water should almost fill the lower portion of the tank. You can do this by looking into the gap
where the flames come out. Make sure water is suitably clean and clear.
!
Check for combustible objects and objects that you do not wish to get wet around the fountain.
!
Clear all people or pets away from the fountain.
!
It may be difficult to see the burner operating in direct sunlight. If you are running the fountain all day without the flame feature, turn
off the gas line valve to prevent unintentional, or unseen burner ignition.
Operating Instructions
Control Box
Control Box Cover
Lock (turn counter-
clockwise to lock,
clockwise to unlock)
Ligh
t
Wate
r
Flam
e
Control Buttons
These L.E.D.s
will illujminate
when “ON”
A control box (see illustration to left) is used to operate all of the features of the Ring of Fire.
NOTE
:
The control box has a built-in lock – we recommend locking the control box when
not in use, preventing unauthorized or unintentional use.
1.
Make sure gas, electrical, and water supplies to the Ring of Fire are turned on.
2. Press
the
LIGHT
and
WATER
button simultaneously for 3 seconds. The lights and
fountain will turn on (if not, repeat this step). At this point the lights or fountain may be
turned on or off using the buttons.
3.
To turn on the flame:
(a) Make sure the fountain is on.
(b) Follow the steps below:
Ligh
t
Wate
r
Flam
e
Press and Hold
the Flame
Button.
Press and Release:
LIGHT
LIGHT
WATER
Ligh
t
Wate
r
Flam
e
Ligh
t
Wate
r
Flam
e
Release the
Flame Button.
The flame should start. If the Ring of Fire was used recently, the flame should come on
immediately. If not, it may take longer. You can hear the clicking of the ignition system
during the ignition cycle. If the flame does not appear within 1 minute, press and release
the
LIGHT
,
WATER
and
FLAME
button individually once. Wait 5 minutes and start with
step 1 above. To turn the flame off, touch the
FLAME
button once.
NOTE
:
It is not unusual to intermittently smell the odor of gas and its byproducts when the
unit is burning in windy conditions. If you have the flame feature “ON” and smell
gas without the presence of flames, turn off the flame feature and call your dealer or
gas supplier.
4.
The light, water, and flame can be operated independently by pressing and releasing the
buttons on the control box. For safety reasons, the flame can only be turned on if the water
is turned on. Therefore, if the flame is turned on, turning the water off will also turn the
flame off.
5.
Turning all features off will reset the Ring of Fire. The start-up sequence from step 2 will
have to be repeated.
NOTE
:
The flame will be automatically shut off if left “ON” for two hours (the light and
fountain will continue to operate). This safety (and economical) feature prevents
unattended operation and needless consumption of gas. The flame may be turned
back on immediately by pressing the
FLAME
button..
10” to 16”
NOTE
:
During normal operation, the flame tips have peaks and valleys ranging from 10 to
16 inches. For clarity, the above illustration is shown without water sprays
