60
SECTION 9
SLIDEOUT SYSTEMS
the side of the seal to avoid the possibility of
water penetration.
Retracting slideout room
Press the IN section of the slideout control
switch and hold it until the motor stops.
Operating the switch after the room is fully
retracted will damage the switch and motor.
Maintenance
Do not work on your system unless the 12-
volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical
systems (shore line power cord) have been
‰
Follow steps on overriding the specific
slideout system installed on your RV.
‰
You may need to push the side that is not
sliding to get it to retract all the way.
‰
Contact your dealer or Travel Lite
Customer
Service for repair
RBW Slideout override
Inside the RV, locate
the hex head screw
on the front of the
slide motor. Using a
ratchet
and
3/4"
socket, turn the
screw counter-
clockwise to retract
disconnected.
Your slideout system has been designed to
the slideout. Install
the travel bars in the
proper locations as
Fig. 9.4 RBW slide hex
head
require very little maintenance. To ensure a
long life of your slideout system, read,
understand
and
follow
these
simple
instructions. This system contains a pre-lubed
bearing that is lubricated when the room is
moved in and out. Do not spray oil or grease
on the rails while the room is extended.
T
ROUBLESHOOTING
T
HE
S
LIDEOUT
If the slideout does not move when the
slideout switch is depressed, follow these
steps.
‰
Check the auxiliary battery (customer
supplied) for a full charge and good wire
indicated by the wall labels.
Dexter Chassis Group (DCG) Center Drive
Slide override (flush floor models)
Disconnect the slideout motor brake wires
from the power wires. Connect a 9 volt battery
harness to the
motor
brake
wires Locate
the
manual
advance crank
nut
on
the
backside of the
motor. Crank
the nut on the
connections.
‰
Check the 12-volt fuse or circuit breaker.
slideout motor
with
a
5/8”
socket. With
Fig. 9.5 DCG manual advance
crank nut
‰
Check for loose connections at the
slideout motor.
If the slideout still will not operate, follow
these steps.
‰
If the slideout is extended, refer to the
following section on overriding the specific
slideout system installed on your RV.
‰
If the slideout is retracted, leave it in that
position.
‰
Contact your dealer or Travel Lite
Customer
Service for repair assistance.
If the slideout extends crooked or only one
side opens, follow these steps.
side moves, follow these steps.
57
