G E T T I N G S T A R T E D
5
Recharging MC Battery
1.
Plug
the Makita quick charger (Figure 3) into
a standard 110V wall outlet. This charger is
provided with all powered TraumaFX®
systems.
2.
Slide
the battery onto the quick charger until
firmly in place and the indicator light
illuminates (each battery takes approximately
15-30 minutes to charge, and depending on
the amount of usage, provides up to 4 hours
of training support).
3.
Remove
the battery when readout indicates
charging is complete.
NOTE:
A 220V Makita charger is available for International use. This is a special
order item and available for purchase through TraumaFX by contacting customer
support or your account representative.
General Use and Care of Batteries
All batteries used in TraumaFX products were specially selected to provide optimal
operational performance. However, as with all batteries, they will last longer with
proper care and maintenance. To preserve the life of the batteries, the following
best practices are recommended:
1.
Only use the batteries and charger(s) provided by TraumaFX; use of
different equipment may result in damage to the batteries and/or the
TraumaFX unit(s).
2.
Remove all batteries from the MC at the end of each training session.
Batteries should never be stored inside a unit, MC, or RC transmitter.
3.
Recharge batteries immediately after use by placing them in the Makita
battery charger.
4.
Fully recharge all batteries before each training exercise. This is
indicated by a solid green light on the charger for each battery.
5.
Never mix a fully charged battery with a partially charged battery as
this will cause the TraumaFX unit to not operate properly.
6.
Never mix an old battery with a new battery as this will quickly degrade
the new battery.
Figure 3
